Posted on

A Crumble-Powered Automatic RGB Nightlight

Sometimes inspiration can be hard to come by. We have known for a while that we’ve wanted to make a nightlight, but didn’t know how to make it different from all the rest.

We stumbled across an interesting video on YouTube which peaked our interest and gave us the inspiration we needed. How awesome would this nightlight look if we added a whole heap of Sparkles (a Matrix display) and gave it a Crumble kick?!

The Crumble-powered RGB nightlight was born.

Although this post will be a whistle-stop tour of the process, when we have our finished Sparkle Matrix display, we will definitely work on some in-depth instructions and teaching resources.

We started off by preparing a cardboard box, by removing all of the sellotape. We then glued it back together, to make sure that it was sturdy.

We then cut the faces of the box off, leaving a border. This would give us the frame for our light.

After this, we drew some straight lines on a word document and printed off 5 copies. We then trimmed each sheet so that it could be glued inside the 5 faces of the frame.

When we had finished our light, we decided that we didn’t like the bare cardboard, so we used a silver permanent marker to give it a metallic look.

Wiring up the Crumble was simple enough.  After connecting the Sparkles (inside the shade), we connected a light-dependent resistor (LDR). One end connected to a + output, in this case from the batteries, and the other end connects to an input (A, B, C or D). We used A.

It’s really easy to use an LDR with the Crumble. Take a look at the following program. When the analogue value of the LDR (we’ve renamed it to be helpful) is above 90, turn all of the Sparkles off,  if it isn’t above 90, and therefore less than it,  then turn the Sparkles on.

To get the nice RGB effect, we have cycled through the red, green and blue values.  This graph shows how increasing or decreasing the different values gives us different colours. Doing it in this particular order gives us a lovely rainbow effect!

We have created variables called Red, Green and Blue. We then set the corresponding red, green and blue Sparkle values to our variables. We have cycled up/down the RGB values to give us our transition of colours. Each time the colour changes, we check to see the value of the LDR, and whether or not to turn the lights on/off.

And here is our RGB nightlight, in all of its glory! When the Sparkle Matrix gets finalised, we will create some more in-depth teaching resources for this project, as it’s easy to make and really satisfying.

Leave a Reply

Your email address will not be published. Required fields are marked *